TM Gen CNC program adaptation for SHARNOA
Controller : Tiger7
Example: M19x1x10
Holder: RTMC2517-26S2
1		run TM Gen for FANUC
2		save to disk programs
Fanuc		%
Sharnoa	N10		remove % - add N line numberring to all lines
Fanuc		O0001 (TMINRH CLIMB Cycles= 1)
Sharnoa	N20	/ O0001 (TMINRH CLIMB Cycles= 1)	Add / Before note
Fanuc		(Tool cutting diameter = 17 mm - Fanuc 11M Controller.)
Sharnoa	N30	/ (Tool cutting diameter = 17 mm - Sharnoa Controller.)	Add / Before note+ change fanuc to Sharnoa
Fanuc		G90G00G57X0Y0
Sharnoa	N40	X0Y0	Remove G90 & G57
Fanuc		G43 H10 Z0 M3 S1497
Sharnoa	N50	G40 T10 Z0 M3 S1497	Remove G43 change H10 to G40 T10 (tool length compensation)
Fanuc		G91 G00 X0 Y0 Z-10.239
Sharnoa	N60	G00 X/0 Y/0 Z/-10.239	Remove G91 - by Add / for incremental
Fanuc		G01 G41 D60 X0.632 Y-8.905 Z0 F20
Sharnoa	N70	G01 G41 T10 X/ 0.632 Y/ -8.905 Z/ 0 F20	Change D60 To T10- add / for incremental (G91 active)
Fanuc		G91 G03 X8.905 Y8.905 Z0.091 R8.905 F20
Sharnoa	N80	G03 X/ 8.905 Y/ 8.905 Z/ 0.091 R8.905 F20	Remove G91 - by Add / for incremental.
Fanuc		G91G03 X0 Y0 Z1.0 I-9.536 J0 F20
Sharnoa	N90	G03 X/ 0 Y/ 0 Z/ 1.0 R-9.536 F20	Remove G91 - by Add / for incremental. -parralel thread - Write minus sign R- …Value of I . Conical thread lines With I & J calculate R = Square Root (I*I+J*J) ,write Plus sigh R …, Remove I J
Fanuc		G91 G03 X-8.905 Y8.905 Z0.091 R8.905
Sharnoa	N100	G03 X/ -8.905 Y/ 8.905 Z/ 0.091 R8.905	Remove G91 - by Add / for incremental.
Fanuc		G00 G40 X-0.632 Y-8.905 Z0
Sharnoa	N110	G00 G40 X/ -0.632 Y/ -8.905 Z/ 0	add / for incremental ( G91 active)
Fanuc		G90 G00 Z200.0
Sharnoa	N120	G00 Z200.0	Remove G90
Fanuc		G49 M5
Sharnoa	N130	M5	Remove G49
Fanuc		M30
Sharnoa	N140	M30	add N line numberring
Fanuc		%
Sharnoa	N150		remove %